PUMPKIN CAR STEREO SUPPORT CENTER

Hi,
pressing the power button just makes the unit in the standby mode,not a really power off.
Regards

It's a very deep stand by ! Because it takes 20-30 seconds to turn on...

Today , new problem ...

https://youtu.be/B8fIyyuZkI4

Hi, here is the firmware for your unit .You can have a try.And you can do as the video.
https://mega.nz/#!5JUkhTrQ!TzJVM1QuDCfh ... BfwUabE_Nc
https://www.youtube.com/watch?v=S8Go80q4LB0
Regards

Hi,
After reset, the unit works properly.
Except that the backlight stays on if I let the + acc.
Regards.

Hi,
Yesterday, after one hour of operation, the sound cut on the front speakers.
I moved the fader and the sound came back ... New problem!
And today the unit did not want to start.
I had to make a reset again.
I think I will flash the firmware as soon as I have time.
I feel like a beta tester!
Regards.

Hi.

This is a video of residual light when I turn off the unit with the ignition on.

https://youtu.be/zX05floJNdI

If I turn off the ignition before the unit is turned off, no residual light.

I will put another video soon.

There is an icon just to the left of the thread title that takes you to the first unread post. It appears in the thread list page and not in the actual thread itself.

Hello,

This is what happens when I pulled out the car key when the screen retracts, no residual light.

https://youtu.be/dpqGjMMfNBE

Regards.

Hi,
very thanks for your two videos.
We now find it is the software bug.Once there is solution for this,i will notice you here.
But first ,didn't the unit close the screen after you directly plug the car key out? if it is ,you should try to pull the car stereo out and exchange the yellow wire and the red wire from the power cable.
Normally,after you plug the key out ,the unit will close the screen and you will not find the weak light which you suffered .
Regards