PUMPKIN CAR STEREO SUPPORT CENTER

Recently, we have received that some customers need the developer code. But due to some reason, we do not have the code. What we need to remind that we do not need to use developer mode normally. However, if you really want to full control the head unit, one of our partners has found a way that can enter the developer mode without code. Must remind that you need to have good knowledge about the Android head unit before using this way.

The ADB tool: Adb.clockworkmod.com

Download the ADB and connect with the IP Address of the head unit.
Open ADB shell settings.
Enter global development, click settings.
Choose enabled 1.

Notice: Only if you flash a new firmware, it should be possible that you have to activate it again.

imgpsh_fullsize_anim.png (45.27 KiB) Viewed 11460 times

imgpsh_fullsize_anim (1).png (55.49 KiB) Viewed 11460 times

Hi, if the above method is too complicated try this: go to factory settings, type code ADBON and press enter/complete. Developer options menu then appears.

Hi ksandward,

Thank you so much.