]]>
The ones i got last time was 800kb and 38byte.
Tryed to update and it counted up all 4 files as "done".
took about 30 min.
Still i am stuck on boot.
I took some pictures that show how it looked
Statistics: Posted by Nossnahoj — Thu Dec 07, 2017 9:08 pm
]]>
https://mega.nz/#!tINzRSRD!TTEw4ELCq5Pe ... u-BrdEkvd4
Unzip the rar files to the root content of one sd card/USB stick and then as you did before.
Hope your feedback.
There is no recovery mode for this unit,but there is a boot files to make the difference.
Regards
Statistics: Posted by Jammy — Thu Dec 07, 2017 6:23 am
]]>
When i put sd-card in gps-slot card is not found. However.
When i put file on a usb-stick and place it in usb, the "update start" and a green bar completes.
Then it say "Update end".
BUT still the same boot-error.
How can i get in to recovery-mode ?? (like on a android cellphone) and try a factory reset.
I think my logo-picture may have wrong size and locking up the boot...
//Best regards Pelle
Statistics: Posted by Nossnahoj — Wed Dec 06, 2017 9:59 pm
]]>
About your problem,please ignore the firmware before.
1. Firstly ,download the following files to the root content of one sd card .
https://mega.nz/#!lc03XDZS!h-JqsApkPC9S ... SosiWXxZPY
You can refer to the following video to enter into recovery mode to flash the unit.
https://www.youtube.com/watch?v=S8Go80q4LB0
2.After flash successfully, click the RST button to reset the unit again.
3.Next, clear up the above files from the sd card.
4.Then download this files to the root content of the sd card and do as step 1.
https://mega.nz/#!ZMl2jCbY!XLrrvfYwvlem ... aCe-C42kn0
I know that you consult the customer before,we are belong to the same team, you can continue contacting the customer service if you have any query.
Regards
Statistics: Posted by Jammy — Wed Dec 06, 2017 10:15 am
]]>
Get stuck on a distored picture off my logo.
I need the right files to install a new firmware.
Cant find them i forum.
Statistics: Posted by Nossnahoj — Mon Dec 04, 2017 11:57 pm
]]>