The reverse camera detective wire and cam in RCA video input cable are as below shown.
Please refer our another forum to install the reverse camera.
viewtopic.php?f=14&t=22
Regards
Statistics: Posted by Jammy — Fri Mar 24, 2017 10:46 am
]]>
The screen does not change when I put the vehicle into reverse. Does the top white connector on the original, which moves to the top socket on the new unit, include the camera? On the original, there are two round sockets on the bottom right. As far as I can tell, the larger one is the radio aerial (because I could tune in the radio after plugging it in). Is the smaller one for the camera input? If so, will it work with the new unit's cable with the green AV-style plug (number 10 in the above image)? I am wondering if I should plug in that cable harness and then plug in the jack that I took out of the smaller socket.
Statistics: Posted by SDeuchars — Wed Mar 22, 2017 4:22 pm
]]>
You just need to connect the cable which should connect to your original radio to the corresponding position of our uni.
For other original cables, such as your original navigation cable and original USB cable, just leave them alone.
Regards
Statistics: Posted by Jammy — Wed Mar 22, 2017 2:33 am
]]>
Car: Toyota Alphard Hybrid 2003
Original head unit: Toyota 86120-58050
Front:
Rear:
The bottom row of black-white-white sockets fit the power section on the LM-W0674. I do not know what the top row of white-blue-grey sockets on the original are; there is nowhere on the Pumpkin unit for them to plug into. The Pumpkin unit came with a load of jacks that I cannot connect to the car wiring.
Statistics: Posted by SDeuchars — Mon Mar 20, 2017 8:54 pm
]]>