PUMPKIN CAR STEREO SUPPORT CENTER

Thanks, so i can stop searching

Hi, you're sure that 12V and ignition are properly connected? I set my 276 to 2 hours to standby. When i play around a while with ignition on but motor off and than switch the motor on, there's no problem - the unit stays on without any problem. My former Pioneer F20BT always shut down when starting...

Hi Thomas, i think i know what you mean: In the setup menu is written "press volume up/down to select....." This does'nt work on my unit either. To move the highlightet option, i have to press shortly the reset button. To activate the highlightet option, i have to push the reset button a f...

Hi Jammy, thanks for your support. But before i flash the firmware again i would like to know, if the unit has built in sensors. Even the elixir app does'nt find any sensor , even if there is no ODB-bluetooth adapter is installed. I talk about internal sensors in the headunit, like acceleration, pro...

Hi, meanwhile, my RQ276E works about fine in the car. Amazon order number is 302-9991654-6653104, Model.Nr.: S07 MCU: MTCC-KLD6-V2.91 May 31 2016 19:54.:14 Android 5.1.1 1024*400 Kernel 3.0.101+ root@chun #42 Tue May 17 21:50:34 CST 2016 Build rk3188-userdebug 22062016.16:41:09 I use torque pro to r...

Hi Jammy,

thanks again!!!!

The MCU is installed again and works.
The firmware you sended here is different from the firmware you sended in the other thread "differences between...." Wich one is the correkt version as the unit was delivered?

Thanks

Michael

i found the solution :D : i was able to"debrick" my unit using a USB-Keyboard and pressing "e" while holding "alt" and "print". Then i flashed another MCU (an older one 1.85, not the missing original) and different firmwares (HuiFei Stock and Malaysk, Android ...

Hi Jammy,

thanks for the link!

But could you please send me also a link to the original MCU MTCC-KLD6-V2.91, May 31 2016 19:54.:14 ?

Thanks and regards

Michael

just to push the thread up:

My 0276E is still a brick after the suggestet MCU update.
Would it be possible to get the original MCU back and the original firmware as it seems that these is corrupted?

Thanks

Michael

Hi, i have two 7", 1024*600, 5.1.1 units here (RQ0276E and RQ0259E). If connected red and yellow wire to the battery, they both take about 500-600 mA in Standby (screen off) In normal mode (Screen on) and Volume to 0, they take about 900 mA. I thlink it's a bit to much to leave the unit always ...