PUMPKIN CAR STEREO SUPPORT CENTER

Dear Pumpkin, I have this RQ0261E one year old Naviceiver and it start making following problem. Ii automaticlly start turning on & off Volume up and down like someone is pressing the remote buttons. It never did it before. I removed the battery out of the remote and it still does it. Second I h...

How comes nobody is helping here. I have the same issue. How can I increase the memory

Since Jammy is gone I will try again. The display is hard to see and very dark compared to and tablet.

Do you have a fix developed to increase the brightness of the Display?
In addition, did pumpkin stopped selling RQ0261E?

Regards Bob

Hello Sammy does the RQ0261E support steering wheel controls.

Does it has 5V Key2 & 5V KEY1 and GND connections in the back.


Thank you

Dear Sammy

are the inputs of AV in & Cam in are having different filters?

Thank you
monette

Hello Barfly, I have hooked up the camera on a short cable the picture was perfect. I have tried two other cameras as well. Same result. If I am using a long cable all cameras a making issues. I assume the low cost cable which is in the pruchase included is not a coax neither twisted. I will change ...

Dear Sammy

are the inputs of AV in & Cam in are having different filters? AV in shows noises effect and the reverse Cam In picture is okay.
I have the concern that the input filter of AV is not as good as for reverse cam in.

Thank you
monette

Monette- You have noise induced by the length of the poor quality cable. To mitigate the problem get a good quality 75ohm co-axial cable, preferably copper and replace the thin audio cable with this new one. If you can't find suitable plug ends, just cut your old cable 3-4 inches from the ends and ...

Dear All & Barfly, thank you I will go with your proposal and purchase a twisted & shield cable with min 4 and shield. Signal composiute Signal GND Shield (connect to signal GND) and Supply & GND for 12V I will use a twisted pair with an outer shield. hope that solves my issues. Thank yo...

Dear Sammy thank you for your response. I have tried another cam and it showed the same issue. I have a camper using a long cable. Can be cable damping the root cause? I have some technical questions. What transmission protocol is the AV in using. Is it the Composite protocol? What signal to noise r...