PUMPKIN CAR STEREO SUPPORT CENTER

Hello,

I have purchased the following unit from your store on Amazon:

https://www.amazon.de/gp/product/B06XSD ... _qh_dp_hza

My car (VW Tiguan 5N 2013) has 8 speakers, 4 on front doors and 4 on back doors (pics at the end of the post). They were all working very good with the original stereo unit RNS-315 . Only 3 cables were attached to the original RNS-315:
- GPS cable (blue)
- One Radio cable with two heads
- Quadlock cable

Here is a diagram of the original RNS-315:


And here is the right back side:


And here is the left back side:


And the quadlock:



I have connected your unit exactly the same way. Only my car's GPS cable didn't fit and needed an extra fakra adapter (extra purchased). Now the problem is: The audio (music, radio..etc) comes only from 4 speakers (2 upper front and back). The pre-installed application "amplifier" shows only 4 speakers also. Can you please tell me how to make all the original 8 speakers work since they were working with the old original unit RNS-315? I have no Dynaudio. It is VW Sound System.

speaker_Right_FrontDoor_Up.jpg (414.36 KiB) Viewed 2699 times

speaker_Right_FrontDoor_Down.jpg (467.21 KiB) Viewed 2699 times

speaker_Right_BackDoor_Up.jpg (271.87 KiB) Viewed 2699 times

speaker_Right_BackDoor_Down.jpg (481.45 KiB) Viewed 2699 times

speaker_Left_FrontDoor_Up.jpg (453.71 KiB) Viewed 2699 times

speaker_Left_FrontDoor_Down.jpg (397.73 KiB) Viewed 2699 times

speaker_Left_BackDoor_Up.jpg (605.85 KiB) Viewed 2699 times

speaker_Left_BackDoor_Down.jpg (638.47 KiB) Viewed 2699 times

Hi,
You only need to insert the speaker conector into the unit and the 8 speaker can work normally.
Regards

Thanks for the answer. Which speaker connector? Only the 3 cables above were connected to the original RNS-315, no extra speaker connector. Can you show me a picture or point it out in the pictures I posted above?

Hi,
you need to insert the Quadlock cable into the regarding rear connector of the unit.

QQ截图20170713151203.png (772 KiB) Viewed 2684 times

QQ图片20170713151544.jpg (86.56 KiB) Viewed 2684 times

QQ图片20170713151534.jpg (75.42 KiB) Viewed 2684 times

Regards

Hello, thanks for the pics. Of course the quadlock cable was connected otherwise it wouldn't have been possible for me to tell you that 4 speakers only work. So the quadlock is connected but your unit powers only 4 speakers at a time. Could it be the DIP switch at the back? I have set all pins to off (down position).

Hi,
sorry for misunderstand you.
Our unit has 4 channel audio out put like your original stereo RNS-315.Are you sure your original stereo can control 8 speakers?
Regards

Hello, as shown in the pictures above my car has 2 speakers (small and bigger one) on each door => 8 speakers. Here is a video of a car that is like mine:

https://www.youtube.com/watch?v=aQNdhlp7lrQ

In the video description one can see:
"RNS 315 touch screen navigation with radio/MP3 compatible CD player 8 speakers + aux-in"

That is exactly what I have (this is not Dynaudio). I think there is something different in your unit than the RNS-315 regarding frequency distribution ( i am not an expert here).