Next I will show you detailed installation operations for Mazda 6.
1.Unclip and remove the cup holder panel in the center console
- 1.png (246.62 KiB) Viewed 15006 times
2.Unscrew and remove the shift knob,then remove the small pocket panel
- 2.png (207.43 KiB) Viewed 15006 times
3.Unclip and remove trim panels(total 2) beside the shift knob
- 3.png (227.44 KiB) Viewed 15006 times
4.Fasten and remove center trim panel,if you feel hard to do it,then you operate next step first
- 4.png (214.87 KiB) Viewed 15006 times
5.Press in shifter fasten trigger and pull shifter down,make sure a brake on! After this,you can remove the center trim panel
- 5.png (200.8 KiB) Viewed 15006 times
6.Remove two Phillips screws on each side of the center consoles,then remove center consoles
- 6.png (251.67 KiB) Viewed 15006 times
7.Remove left screw and right bolt
- 7.png (218.69 KiB) Viewed 15006 times
8.Fasten and remove the vent panel including the hazard switch above the original player
- 8.png (162 KiB) Viewed 15006 times
9.Remove these two screws with a screwdriver
- 9.png (213.13 KiB) Viewed 15006 times
10.Take out original stereo autoradio and disconnect cables with the help of suitable tools
- 10.png (187.07 KiB) Viewed 15006 times
- 10-1.png (221.41 KiB) Viewed 15006 times
11.Unclip this bolt and make most fine connected here and firm by that bolt
- 11.png (188.88 KiB) Viewed 15006 times
- 11-1.png (194.95 KiB) Viewed 15006 times
12.Plug these plugs as the picture show
13.After cables are settled to right positions,put new unit into the space
14.Make all set-aside panels back to its original place and firm corresponding screws and shift knob
All installation work has been finished.Before you are begin to install Mazda 6 aftermarket gps navigation, there are some tips to mind:
1.Make sure that you have accomplished car’s parking series before you begin any work
2.Plesae do not use any strong chemicals or cleansers clean the unit
3.When you are installing the wiring, make it as neatly as possible, because the space for it is very small
4.Please don’t remove the GPS SD card when the power is on
To be honest,most of the installation process of radio gps nav system for Mazda series are same in a large proportion,of course it may have some difference during your work,but don’t worry,this is normal and all will be solved only if you make adequate preparation before you start up your removal,such as read installation guide carefully and act as it say,or visit some related websites,for example, and you can also ask dealers for help.
- 3.png (227.44 KiB) Viewed 15006 times
- 7.png (218.69 KiB) Viewed 15006 times