PUMPKIN CAR STEREO SUPPORT CENTER

Dear Guys,
bought a New CN10-03304B.
Installed it on my Passat CC.
All works fine so on, good Job!
Only Problems i have are:
1. After a few Minutes i start the Radio it Hooks up with a Scretching Sound. No more Input is accepted.
Had to push Power Off till it is in Standby and restart it again and everthing works fine.

2. Sometimes if i start the Car, there are all Speakers activ except the Tweeters.
Same Solution: Restart the Unit and everything is fine.

For sure its really irritating if both Problems come the same Time and i have to restart the Unit every Time.

Can you help me with that Problems?

IMG_20180115_221702.jpg (2.25 MiB) Viewed 1197 times

Hi,
here is the firmware you can have a try .
https://mega.nz/#!VJ1hARRS!GNm5rjB6yGm8 ... lJgnUva6zk
Please download and unzip the files to the root content of one sd card and insert it into the GPS slot.Then enter settings - car setting - system update.
Regards

Hi again Jammy,
tested the Update today, Updating all went fine.
The Problem with the Speakers/Tweeters seems solved. No Problem on a few drives today.
But that the Unit stucks after a few Minutes is still there / heavier than before.
Crashes no more often i think than before.
Have Uploaded a Video to show you what exactly happens:

https://youtu.be/A-jnr0BwBMQ

So i need to Pull the Unit Off, after pulling on everthing works fine.
Need some more help..
Can it be a Hardware Issue?

Greetings

Hi, you can enter settings - car settings - extra settings - model choose page to choose the option " VW OBD (ss)...".

1801.png (51.95 KiB) Viewed 1177 times

Regards

Hi Jammy,
Think we found the Problem,
I have NO Models that i can choose.
How can i get them?

IMG_20180118_130925.jpg (4.02 MiB) Viewed 1169 times

Hi,
we just get the latest firmware .you can have a try.
https://mega.nz/#!pQ01gQKQ!xBvReKvVa_zJ ... ryj5CSsXEo
Regards

Jammy,
Tried the New Firmware. Flashing was finde and works.
But still the same Problem aß before. Crashes after few Minutes.
Wondering that i still can't choose the Model. No one is listed here.
Think here is Our Problem.
You have a file to flash where i can get them?
Or is it a Hardware Problem?

Hi，
it is very strange.
So here is the mcu files you can have a try.
https://mega.nz/#!wMllkSwQ!KCk1LYkjH6r6 ... VJcKLXAbJ8
Download the files to the root content of one sd card and insert it into the GPS slot. Then enter settings - car settings - mcu update.
Regards