Mazda 6 S07 device. MCU MTCB-KLD2-V2.79. REQUIRE RE-INSTALL FILES PLEASE

[Snootchies]

Hi There. I have a Mazda 6 with a S07 based android device. MCU version is MTCB-KLD2-V2.79

I recently reset the device to factory as it was starting to get slower and thought it would solve it.

However the device won't go beyond the Mazda logo at the start. I can put the device in recovery mode, so If I could please have the install files for it, I'll simply reinstall the operating system again.

Here's a pic I took of it when it was working.

IMG_2671.jpg (1.36 MiB) Viewed 957 times

Thanks.

[Jammy]

Hi,
you can contact the pumpkin customer service or write to support@autopumpkin.com .Please tell them your order number or ebay buyer id so that they can confirm your unit.Please also tell them the screen resolution of your unit if you know.
Thanks.

[Snootchies]

Thanks for replying. The android system came with the car I purchased, so I have no order number to provide.

[Jammy]

Hi,
ok. You can flash the following firmware.
https://mega.nz/#!3CA0zCJY!qgJ56fncDIcq ... G1UKnFG66g
Please download the files to the root content of one sd card then insert it into the GPS slot .Then do as the following video .
https://www.youtube.com/watch?v=Vtfwfh0Olu4
Regards