PUMPKIN CAR STEREO SUPPORT CENTER

Sorry for my Bad english But i have a Little Problem. I bought a 6.0.1 pumpkin Radio for my 350z with a bose converter for steering Wheel. The Problem is, i cant config Any Buttons With the Software. The wires key 1 and key 2 are right connected .... i Hope

I Would ask if Maybe a Firmware Update is available(it Would be nice if 7.0 works but i think the Hardware is different.

If Would ne Great if someone could help me

Greets from germany

Hi,
did you purchase the power adapter like follows ? You need get one and connect all three white connectors .

adapter.png (1.6 MiB) Viewed 1080 times

Then you need to connect the steering wheel wires.

SWC.png (350.2 KiB) Viewed 1080 times

and then you can using the steeling wheel control .If it still doesn't help,you can remap the buttons on the steering wheel. You can refer to this video .https://www.youtube.com/watch?v=GopA9DXG_Xo&t=8s
More query ,please tell me your order number or ebay buyer id.
Regards

Hi, i have this connector: (i only know that my friend have the same connector and the same car and it works .... he only have a other pumpkin radio).

I connected all 3 + the 3 wires with Key 1, Key 2 and Ground.

And the wheel buttons also works with OEM radio

Hi,
sorry for my bad english. I don't know whether you had solved the problem now according to what you said.
If not,i think you should lost the steering wheel wires connect with the connector 1 and the Key 1,Key2 and Ground from our unit.Or could you tell me how you connect these wires to our unit or your OEM radio .

SWC.png (274.01 KiB) Viewed 1065 times

Regards

Hi, the "connector 2" is connected to the 3 Wires of the Pumpkin Radio what named Key 1, 2 and Ground. The 2 White connectiors, the Iso connector and the 3 wirs are plugged in into the Black converter ... bad to see in this picture sorry

I will soon remove the radio again cause i want a camera and the DAB+ modul ... but i hope someone can say me my mistake

Does any firmware update available?

Hi,
i know.In fact,there should be one steering wheel control cable coming from connector 1, this cable connect the 3 Wires of the Pumpkin Radio what named Key 1, 2 and Ground. And the connector 2(three wires) should be connected to your car connectors. So the SWC signal go through car stereo - connector 1 - connector 2 - car connector.
Regards