PDC don´t work and the system shut down...
Posted: Sun Feb 10, 2019 4:39 pm
Hello all,
I bought Pumpkin PX3 for my Ford Galaxy WA6 (built in 2014). Basically I´m satisfied with the new System, but I have two problems.
Problem #1: PDC don´t work.
My PDC don´t work. I read in this forum to change the Can-Bus in the factory settings, but there is no setting for the Ford Galaxy, only for the Ford Mondeo. Can anybody help which setting I need to choose?
The PDC are in the front and in the back of the car.
Problem #2: shut down of the PX3 system:
If I want to use the PX3 system, I need to push on-button. Basically no problem.
But I also need push the on-button, if I want to shut down the system. So the energy supply in the starter lock has no influence to system.
That means, if I forget to push the button my battery runs low.
I hope you understand my problem.
Can anybody help?
Thank you for your support.
moshpotatoo
I bought Pumpkin PX3 for my Ford Galaxy WA6 (built in 2014). Basically I´m satisfied with the new System, but I have two problems.
Problem #1: PDC don´t work.
My PDC don´t work. I read in this forum to change the Can-Bus in the factory settings, but there is no setting for the Ford Galaxy, only for the Ford Mondeo. Can anybody help which setting I need to choose?
The PDC are in the front and in the back of the car.
Problem #2: shut down of the PX3 system:
If I want to use the PX3 system, I need to push on-button. Basically no problem.
But I also need push the on-button, if I want to shut down the system. So the energy supply in the starter lock has no influence to system.
That means, if I forget to push the button my battery runs low.
I hope you understand my problem.
Can anybody help?
Thank you for your support.
moshpotatoo