Page 1 of 1
27-aqtu72-03 steering wheel controls
Posted: Mon Mar 27, 2017 2:52 pm
by Kablooey
I am using an AXXESS ASWC-1 adapter to send steering wheel control to the device. The device detects some, but not all, button presses and the button programming is not working. I am able to send a button press, then press the corresponding button in the steering wheel control program, it actually says "learning successful", but the button does not work.
Re: 27-aqtu72-03 steering wheel controls
Posted: Tue Mar 28, 2017 9:27 am
by Jammy
Hi,
Could you please tell us the kind of your car?
For the steering wheel control, you can refer our another forum about how to connect and use the steering wheel control.
viewtopic.php?f=3&t=8Regards
Re: 27-aqtu72-03 steering wheel controls
Posted: Tue Mar 28, 2017 3:37 pm
by Kablooey
I have an 08 Honda Pilot which outputs digital signals. I use the AXXESS ASWC-1 to convert those signals to a varied resistance.
I have seen that forum already. It is a) referring to a different software interface for a different Pumpkin device, and b) only wiring instructions. I have the unit wired correctly, it just doesn't work. Please advise.
Re: 27-aqtu72-03 steering wheel controls
Posted: Wed Mar 29, 2017 10:03 am
by Jammy
Hi,
For the steering wheel control, this unit can support the swc based on resistance analog signal.
According to our experience, your car does not need to use the ASWC-1, just find the correct steering wheel wire and connect it to W+1 and W+2, then go to the settings--key menu to learn.
Could you please take some picture to help us check? the not working buttons, and the connection cable included the ASWC-1.
Regards