PUMPKIN CAR STEREO SUPPORT CENTER

Hello - I am new to the forum and first my thanks for all the great information!

I have the single-din motorized panel radio, which is great (model CN10-01201B-08A).
The panel angle has what appears to be 4 or 5 step adjustment, running from about 110 degrees down to 90 from the opening horizontal plane.
My installation requires I have an angle closer to 55 degrees from horizontal plane. How do I set that up?

thanks in advance.

Hi,
the panel angle at least 90 degrees.
Regards

I have just bought pumpkin motorised single din head unit not sure off the model number there are selling it at £242 on there Web site I was wondering how you can alter the angle of screen going too far back.

Jammy - thank you - the minimum angle is 90 degrees, with the max being probably 110 degrees.

My installation requires the angle to be 25-40 degrees. The radio is installed on the center console just above the gear shifter, in a nearly horizontal surface. When the panel opens it only needs to move very little, and then it hits the vertical surface of the console.
Is it possible to give me firmware that allows the panel more adjustment? This would be very helpful. Otherwise the radio does not fit and I have to return it. Which I'd hate since I like the radio.

I also will need better "Motorized panel angle" adjustment for installation in my 944 turbo. I was able to make a Kenwood KVT-514 single din DVD player work well since it had adequate position and angle adjustments.