LM-W0352+Y0811 VW logo

[cookiedude2002]

Hello there i just bought LM-W0352+Y0811 from amazon.co.uk and i thought that it would have come preloaded with the VW logo. But when i operate the unit there is a picture of the world where the VW logo should be. I was wondering can i download the logo from somewhere else or is there a way to access it on the unit.

[Jammy]

Hi, you can go to the Setup--General--Factory se(3368)--Logo Set to choose the VW or Skoda logo.
Regards

[cookiedude2002]

i've tried that but there are no logos there just a picture of the earth.

[cookiedude2002]

i was wondering if you could tell me where i could down load the logos and i could install myself

[Jammy]

Hi,
You can try to use the 800*480, 16bit, BMP format.
Copy the picture into the SD card, insert the SD card into GPS slot, enter the logo set to choose load the logo from SD card.
Regards

[cookiedude2002]

Is there no way you could provide me with an image or link to the image your company uses on your equipment. I would be very grateful if you could sort me out thanks in advance

[Jammy]

Hi,
Here is the link of the VW logo.
https://mega.nz/#!VJ0l1JrD!ZhzLCMxx2pQ9 ... cDUh7XZH6U
Please download and copy it to SD card, insert the SD card into GSP slot.
Then go to the Setup--General--factory set(3368)--logo set to choose "Sd Select", click the VW image on the SD card.
Reboot the unit, then you will get the VW logo showing during the boot process.
Regards

[Kostas1981]

Hi,
Can you please provide me the VW logo because the above link doesnt work anymore. I have the same unit.