PUMPKIN CAR STEREO SUPPORT CENTER

Hello there i just bought LM-W0352+Y0811 from amazon.co.uk and i thought that it would have come preloaded with the VW logo. But when i operate the unit there is a picture of the world where the VW logo should be. I was wondering can i download the logo from somewhere else or is there a way to access it on the unit.

Hi, you can go to the Setup--General--Factory se(3368)--Logo Set to choose the VW or Skoda logo.
Regards

i've tried that but there are no logos there just a picture of the earth.

i was wondering if you could tell me where i could down load the logos and i could install myself

Hi,
You can try to use the 800*480, 16bit, BMP format.
Copy the picture into the SD card, insert the SD card into GPS slot, enter the logo set to choose load the logo from SD card.
Regards

Is there no way you could provide me with an image or link to the image your company uses on your equipment. I would be very grateful if you could sort me out thanks in advance

Hi,
Here is the link of the VW logo.
https://mega.nz/#!VJ0l1JrD!ZhzLCMxx2pQ9 ... cDUh7XZH6U
Please download and copy it to SD card, insert the SD card into GSP slot.
Then go to the Setup--General--factory set(3368)--logo set to choose "Sd Select", click the VW image on the SD card.
Reboot the unit, then you will get the VW logo showing during the boot process.
Regards

Hi,
Can you please provide me the VW logo because the above link doesnt work anymore. I have the same unit.