PUMPKIN CAR STEREO SUPPORT CENTER

Hi all

After I made a new start logo on my pumpkin and made a few updates. Now hang it in the boot screen.
I tried to make a hard reset but I can not get into the menu.
Now I am at a loss.

Pleas help me.

Hi,
Following files is the firmware to solve the unit stuck on the start logo page.
https://mega.nz/#!ZMl2jCbY!XLrrvfYwvlem ... aCe-C42kn0 .
You need to download the files on the root content of an sd card and insert it into the GPS slot. Then you can refer the following video to enter into the recovery page.
https://www.youtube.com/watch?v=S8Go80q4LB0
Regards

I have your file on a newly formatted SD copied.
I gave it to the GPS slot and followed youtube video.
Unfortunately without success. Here you can see the problem.

https://youtu.be/eZyp_vtVXk8

Hi,
sorry,it is my fault.the files is not correct. You can download the following two files.
https://mega.nz/#F!8JEwCQbQ!1lY8mI1X9fBVCYXxFRzXvw
Regards

Hello

The radio loads the update only via USB port. SD card is ignored.
I have all your data loaded with USB. When the loading beam is full, the boot error is returned.
What now?

Hi,
It is strange.
Please first tell me your order number or buyer id in ebay.Please wait for a few days ,once we get an solution ,we will notice you.
Hope your kind understanding.
Regards

Hi

Sry....nope.

Hi,
Please first tell me your order number in amazon or buyer id in ebay,Pumpkin or AliExpress so that we can confirm more information about your unit and provide you positive solutions.
It is strange.Did you ever flash other system before?
Regards