Amp power enable questions

[crankine3]

I am considering buying the 11-RQ0264E+Y0811. I have aftermarket amplifiers in my car, and like typical amps they need an enable signal sent to turn on so they do not drain the battery power. On many android double din radios I am able to see the specific amp enable or amp power on pin in the wiring harness or "ISO Port", and on other Pumpkin radios it is "AMP-CON" on the wiring breakout that handels brake, reverse, illumination and a few other things. I am not able to find a lot of documentation for the 11-RQ0264E+Y0811, and my question is if it has this amp enable signal. Getting a link to more documentation about this particular radio might allow me to answer my own question, but I can't find it on your website at the moment.

[Jammy]

Hi, if you want to use the external amplifier with our unit, normally you just need to connect a couple of audio output cable, such as Rear Out R and Rear Out L. If the external amplifier has the amplifier control wire, you need to connect it to our AMP-COM wire from our ISO power cable.
Regards