Audi A3 2009 C1217 quit Rear sound

[Naxus]

Amazon Bestellnr. 302-2129119-5021131

Not at my car, my cigar lighter is allways on. I can carge my mobile phone anytime there and yes, i control it
with a multimeter and it has 12,6V.
The Radio have not an acc wire, its controlled over the canbus system. The acc port is bridged on the Quadlock with the power cable (on carside). When i connect the two optional Red wires, the radio stays always on. (because
the acc is original bridged with +. Funny is that i can disconnect then the Canbus adapter completely without any dysfunction.

Screenshot_2016-04-21-10-14-52.png (1007.31 KiB) Viewed 2474 times

IMG_20160420_185018.jpg (3.96 MiB) Viewed 2474 times

IMG_20160418_210152.jpg (3.57 MiB) Viewed 2474 times

the original connector, i describe the pins for you
(Sry the white one is not disens, its dsp ein)

IMG_20160418_2101522.jpg (548.44 KiB) Viewed 2474 times

[Jammy]

Hi, sorry for the late reply.
Regarding your rear speaker and unit powering on issue, the factory provide us a new power cable and another canbus decoder for Audi A3.
We can send them to you and you can try to check if they can help you solve the problem.
Normally it will take 1-2 weeks to arrive you, could you please tell us your ideas?
If possible, please contact us via email, here is our customer service email box: support@autopumpkin.com
Hope hear from you soon.
Regards

[Naxus]

Hello and no problem

Thank you, i will wait for the device and cable and give you then information if it function then or not ^^

For future, how about to get in a function that allowed to turn on the radio without acc signal, so the
radio can turn on without key.
The Original radio the acc wire was bridged with the power wire, so the radio can turn on every time.
It has a direct canbus connection and read die acc position over canbus.

best regards
naxus

[Jammy]

Hi,
we will arrange to send the canbus decoder and modification power cable to you ASAP.
Currently we know that there is not a radio which turn on without acc signal, even the car start with the power button, not the key.
If you have any news about this function, please share it with us. Thanks.

[Naxus]

Hello

The new modification power cable arrived and after some research the sound works now perfectly.
On the Cable is now a "filter" box, but its not a filter, it is a amplifier that can adjust with the two
adjust capacitors. With them i adjust the Output volume to the prefect level.
I had to newwire the Chinch system because you have here 2 Stereo amplifier but feed them with
1 Mono signal each. by that the signal was also reversed and cancel each other out. After rewireing it, its works fine

IMG_20160509_220005.jpg (1.28 MiB) Viewed 2420 times

So first problem solved

Second was that it turn off after turn off ignition. I asked audi and at my model the acc signal goes over the canbussystem.
The Canbus adapter use the ignition signal not the acc signal over the canbus system. Is there a way to change that?

Best regards
naxus

[Jammy]

Hi, cause in the past few days the forum system occurred error and we spent some time to restore it, in order to keep providing technician service for you, we sent email via our customer service email box "support@autopumpkin.com".
Could you please tell us if you receive it?
If it's convenient for you, please contact us with the email box, the amazon buyer email box or your private email box are all ok.
Regards

[Flekillero46]

My order in Aliexpress is 78973084764487. I have the same problem which my rear sound. My car is a Seat Exeo 2009 and it have a amplifiquer and no bose sound system. Where I can buy the same cable that the other guy? I need it. Thanks

[Jammy]

[blob810]

[Jammy]

Hi,
For the first and second problem which our forum mentioned, you can refer the way we provided to solve them.
About the driver information system from audi, sorry that this unit does not support it.
Regards